Your Cart (Empty)

You have no items in your shopping cart.

Rycote Tac!T XLR Filter

Rycote Tac!T XLR Filter

Be the first to review this product

SKU: SE-RY017022

The Rycote Tac!T (pronounced "Tas-It") filter is an in-line, active "third-order" (18dB/octave) filter with a "knee" at approximately 60Hz. This enables it to pass, unaffected, virtually all of the desired audio, while massively reducing wind and handling noise, and floor transmitted vibrations. The energy in these extreme low frequency and infrasonic sounds can be very high, and if not attenuated, would otherwise cause overloads and disturbances across the entire audio spectrum. 

More

Excl. Tax: £39.00 £46.80 inc. VAT

In stock

Rycote Tac!T XLR Filter
Rycote Tac!T XLR Filter
Excl. Tax: £39.00 £46.80 inc. VAT
  • Call

    0208 995 4664

  • Chat

    Talk to us now

  • Visit Showroom

    9 Vision, Kendal Avenue, London, W3 0AF

Details

The Rycote Tac!T (pronounced "Tas-It") filter is an in-line, active "third-order" (18dB/octave) filter with a "knee" at approximately 60Hz. This enables it to pass, unaffected, virtually all of the desired audio, while massively reducing wind and handling noise, and floor transmitted vibrations. The energy in these extreme low frequency and infrasonic sounds can be very high, and if not attenuated, would otherwise cause overloads and disturbances across the entire audio spectrum. 

The Tac!T filter draws its power from the P48 phantom supply while also passing power on to the microphone. It is electronically symmetrical and does not disturb the intrinsic balance of the microphone circuit, nor does it introduce any signal loss for normal programme frequencies. 

A key feature of the Tac!T filter is that it fits entirely within the body of a Neutrik XX-series XLR connector. It is not switchable, and the electronically buffered circuitry ensures that its performance is consistent for almost all phantom-powered microphones and preamplifiers in general use. 

Tac!T is a fully symmetrical balanced 3rd order filter. It is has a DC path through it so that it can couple phantom power as well as signal.

What is the current draw from the recorder's or mixer's P48 supply?

Current draw is ~necessary~ for the circuit to operate - the device will not work with dynamic microphones that do not pull current. The actual current draw varies with the load used so it is not possible to give a specification figure for it. The circuit demands are very low and with IEC 26815 compliant P48 supplies it is very unlikely to cause any problems. With excessively hungry microphones (eg those that suggest they need the full 10mA available, such as Earthworks), and phantom powering that cannot deliver adequate current, or is significantly under-voltage there ~might~ be problems. The likely outcome is under-performance of the microphone in terms of max SPL etc, or increase in self-noise rather than failure.

Front-end filters on mixers are usually 6 or 12dB/octave, and these give a greater loss of wanted higher frequencies for a given cut of infrasonic or extreme LF noise. The steeper 3rd order filter (18dB/oct) is more effective. This is why the Schoeps Cut 1 and similar filters are liked by many recordists. In some cases internal filters are also fitted after a transformer and/or first amp stage - in that case these parts of the circuit can be overloaded before the internal HPF can act. Transformer inputs are particularly susceptible to infrasonic overload.

Tac!T can be used in conjunction with internal mixer filters to give a dual slope HPF, but is perhaps of greatest value in applications such as camera inputs where no LF tailoring is provided at all.

Tac!T FILTER TYPICAL PERFORMANCE
Signal loss
0dB @ 1kHz,
-3dB @ 63Hz,
-40dB @ 14Hz
Introduced noise (22Hz -22kHz) - 1.5dB
Max signal level +3dBu (<0.2% distortion)

SPECIFICATIONS
Cable Length:     45cm (18")
Cable diameter:  OD 4.8 mm
Connectors:        Neutrik® XX series, XLRm3* to female XLRf3, Black casing, gold pins
Cable Type:        Ultra flexible Mogami® W2893 star-quad cable


Rycote Tac!T XLR Filter

Rycote Tac!T XLR Filter.

  • Price: £46.80 - In stock
  • Brand: Rycote

Write Your Own Review

How do you rate this product? *

  1. Quality

  2. Price

  3. Performance

Competitive Prices

Competitive Prices

Prokit will always price competitively and offer a price match service.

Fast Delivery

Fast Delivery

Order by 3pm for next-day delivery on available stock.

London Showroom

London Showroom

The UK's largest production equipment showroom. We often hold seminars, workshops and open days.

Since 1989

Since 1989

Prokit have been offering expert advice since 1989. We are an accredited partner or appointed distributor for all the brands we represent.

Please wait...